SW-16

$50.00

16-circuit direct-input switch board (version 2.2)

SKU: PCBA-0006-0004 Category:
The SW-16 is modular switch-input board that sends switch state information to a P3-ROC over a 2-wire RS-485 serial bus. Each board has 2 separate banks of 8 switch inputs. Each input is pulled up to 12V and detects a switch state change when the input drops below 6V. Switch inputs can therefore be connected directly to:
  • Mechanical switches
  • Opto receivers
  • Hall effect sensors
  • … and many other sensor devices
  SW-16 boards can be chained together over the 2-wire serial bus to extend the number of switch inputs in the system. Each SW-16 board has a set of dipswitches for uniquely identifying its address on the bus. The P3-ROC has built-in support for 16 SW-16 boards, representing 256 switch inputs. Note – The P3-ROC is the only PinballControllers.com product that natively connects to one or more SW-16 boards. If you’re using an original P-ROC, you’ll need to wire your switches to its dedicated switch inputs and/or its switch matrix connectors. Also note – Version 2 SW-16 boards have a slightly different pin-out than version 1 boards and are therefore not backwards compatible. The 10-pin headers now include a 12v output on pin 1 and no longer have a key pin, and the serial headers are now 3 pins and numbered in the other direction. If you need version-1 boards, please email us to request quotes and lead-times.
For high volume quotes, please contact us at [email protected].  
 

Documentation

SW-16 (v2) Specifications SW-16 (v1) Specifications
 

Additional Resources

Connectors for use with Multimorphic boards
 

Sample Configuration

Sample Configuration

Additional information

Weight 0.2 lbs